Ideally, you’ll assemble this bench on a flat surface, and even more ideally on the surface you’ll be using the bench. With the legs in the air, like PK below, you need to first set all of the pad bolts in (but not tightening them as you put them in), and once they’re all set in, then slowly tighten them, one by one with your fingers as you make your way around, and around, and around… forever (but really only until all of the bolts are finger-tight and ready to rock). This is not a “tighten one leg then tighten the opposite on the same end and you’re good to go” situation, although we might wish that it could be. Although the ground underneath your bench might be level, your bench won’t be, and it’ll feel wobbly. If you go from this point and tighten down the bolts all the way, you might end up with an off-center alignment. You’ll need to set it up with it’s feet in the air, pad-side down. To get your bench level and sitting purdy sturdy, you’re going to need a ratchet to get the bolts tightened completely. Either the ground where you’ve assembled the bench is unlevel, or the location you’re using it is unlevel compared to the spot you put it together. You’ve assembled the bench in a different location than where you’re going to use it.Much like your own joints, one side is tighter than the other. You’re tightening one leg all the way down and then moving on to the next.“Dead bug” isn’t a great athletic, stable position for you, and it’s not a great position for your bench to be completely assembled in either. We’re going to run you through all 3 of those ways, so you can avoid a wobbly, unlevel bench. #CRISS CROSS WEIGHT PLATES HOW TO#(Don’t worry - we’re also gonna fill you in on how to get a stable, level bench.)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |